Fire Rescue Chief
Public Safety Emergency Manager
1769 E. Moody Blvd. Bldg #3
Bunnell, Florida 32110
Non Emergency 24 Hour
Sheriff's 911 Center
Roof to Top of Wall Connection
Metal hurricane straps or clips provide the proper measure of strength and safety for the roof-to-wall connection. The common practice of toenailing the trusses or rafters often is not sufficient to hold a roof in place in high winds. These clips or straps are usually very difficult to see from the attic because of insulation.
Areas where the roof framing meets the top of stud walls are normally covered by dry wall on the inside and by wall cladding and soffit board on the outside. To install hurricane straps and clips, remove the roof sheathing around the perimeter of the roof to reveal the top of the wall. You may also need to remove the soffit and exterior cladding to reveal the top 12 to 18 inches of the wall. In addition, if the exterior cladding is brick veneer, you may need to remove small sections of brick as needed.
If your roof has trusses, make sure you tie them to the wall by either anchoring to the top plate and then the top plate to the wall stud, or strapping the truss directly to the wall stud.
All Home Protection Articles:
NOTICE: Under Florida law, e-mail addresses are public records. If you do not want your e-mail address released in response to a public records request,do not send electronic mail to this entity. Instead, contact this office by phone or in writing.